On 3/6/2017 12:52 PM, [log in to unmask] wrote: what about drill bits ? > Dell - Internal Use - Confidential > > Ed, > > Thanks for sharing the link. However, that an expensive throw away pin when pin is contaminate with epoxy or bent during extraction. I was looking for a lesser expansive round steel pin price. Straight paper clip wire would work just fine. > > Victor, > > -----Original Message----- > From: Ed Popielarski [mailto:[log in to unmask]] > Sent: Monday, March 6, 2017 2:43 PM > To: TechNet E-Mail Forum <[log in to unmask]>; Hernandez, Victor G <[log in to unmask]> > Subject: RE: Round, Non Critical Tolerance, PWB Index pins > > This might work: > > https://www.mscdirect.com/browse/tn/Measuring-Inspecting/Class-Zz-Minus-Plug-Pin-Gages?searchterm=pin+gage&navid=4287923219#navid=4287923219+4287924734&searchterm=pin+gage > > > Ed Popielarski > Engineering Manager > > > 970 NE 21st Ct. > Oak Harbor, Wa. 98277 > > Ph: 360-675-1322 > Fx: 206-624-0695 > Cl: 360-544-2289 > > > > "It's one kind of victory to slay a beast, move a mountain, and cross a chasm, but it's another kind altogether to realize that the beast, the mountain, and the chasm were of your own design." > https://goo.gl/maps/mMjg43rXeFB2 > > -----Original Message----- > From: TechNet [mailto:[log in to unmask]] On Behalf Of [log in to unmask]<mailto:[log in to unmask]> > Sent: Monday, March 06, 2017 12:14 PM > To: [log in to unmask]<mailto:[log in to unmask]> > Subject: [TN] Round, Non Critical Tolerance, PWB Index pins > > Fellow TechNetters: > > I am searching for a vendor that provides PWB index pins in the diameter range of 8-20 mils. This is for low quantities order of less than 100 pcs. I even considered piano wire. The desire length is 2 inches. > > Victor, > >