Hi Ioan - sorry, I don't have any information on the wire pull portion of your task. Dave On Wed, Dec 14, 2016 at 10:43 AM, Ioan Tempea < [log in to unmask]> wrote: > Thanks Dave, > > I knew you guys were doing a good job in those committees! > > Anything on wire pull, except Dage? > > Best regards, > > Ioan > > De : David Hillman [mailto:[log in to unmask]] > Envoyé : Wednesday, December 14, 2016 10:59 AM > À : TechNet E-Mail Forum; Ioan Tempea > Objet : Re: [TN] Mechanical test equipment for MIL-883 methods 2003 and > 2004 > > Hello Ioan - look in the back of the IPC JSTD 002 specification, Appendix > E. There is solderability equipment information listed there in that > Informative Annex. > > Dave Hillman > Rockwell Collins > IPC-JSTD-002 chairman > > On Wed, Dec 14, 2016 at 8:14 AM, Ioan Tempea <[log in to unmask] > com<mailto:[log in to unmask]>> wrote: > Dear Technos, > > I need to test solderability (per J-STD-002 and method 2003, test B, of > the 883) and lead integrity (method 2004 condition D of the 883) for > leadless components. > > Can you, please, suggest equipment for : > > * Steam aging > > * Solder bath dipping > > * Wire pull; this one is for method 2004, I wonder if anybody is > using regular wire pulling machine (normally used for wire bonds) for this > task. > > Thank you, > > Ioan Tempea, P. Eng. > Manufacturing Engineer, Satellite Systems > > [cid:[log in to unmask]] > > MacDonald, Dettwiler and Associates Corporation, 21025 Trans-Canada > Highway, Ste-Anne-de-Bellevue, QC, Canada H9X 3R2 > Tel: +1-514-457-2150 x3556<tel:%2B1-514-457-2150%20x3556> > www.mdacorporation.com<http://www.mdacorporation.com><http:/ > /www.mdacorporation.com/> > > This e-mail, and any attachments, are intended solely for the use of the > intended recipient(s) and may contain legally privileged, proprietary > and/or confidential information. Any use, disclosure, dissemination, > distribution or copying of this e-mail and any attachments for any purposes > that have not been specifically authorized by the sender is strictly > prohibited. If you are not the intended recipient, please immediately > notify the sender by reply e-mail and permanently delete all copies and > attachments. This email is for informational purposes only and shall not be > interpreted to authorize or conclude a binding agreement between MDA and > any other party unless this email contains or is accompanied by an express > written confirmation of MDA's intention to enter into a binding agreement, > such confirmation shall only be provided by an authorized representative of > MDA. > >