I can do  this for  you Bev , but not clear  on what you  need. 

Can you please markup the image I just sent you and return  back to  me?

I have a caliper and B24 on my desk, 

Rich  Kraszewski 
(920) 969-6075


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bev Christian
Sent: Tuesday, October 11, 2016 10:23 AM
To: [log in to unmask]
Subject: [TN] Need some dimensional info

TechNetters,
Can someone measure one of the actual test patterns of a B-24 board and let me know:
1) the "height" from the outside edge of the thick trace from which the copper fingers extend "down" to the outside edge of the corresponding thick trace at the "bottom" of the test pattern. 
2) The width of the pattern from the outside edge of the left-most "vertical" thin trace to the outside edge of the right-most "vertical" thin trace.

Thanks in advance.

Regards,
Bev

PS: Results in millimeters (to the nearest half millimeter should suffice)
would be nice. SI is not a Communist plot to overthrow the US. :)