Correct. An interesting lesson in clarity or lack of it. I like the quote from someone on TechNet a few years back, referring to a former manager who had degrees in chemistry and English and who had a plaque on his desk saying (approximately), "It is not sufficient that we write in such a way that we can be understood. We must write in such a way that we cannot possibly be misunderstood." Thanks to Denny, Tom and Steve for their good information. I knew the foil people had been working on roughness measurements, and any input from that corner was likely to be more than enough for my needs. Zygo and Tencore I had heard of, but never used and had forgotten. Louis -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of John Burke Sent: Thursday, July 28, 2016 11:56 AM To: [log in to unmask] Subject: Re: [TN] surface profiling I think Louis was referring to profiling of board topography?? Best regards, John Burke > On Jul 28, 2016, at 8:53 AM, Nutting, Phil <[log in to unmask]> wrote: > > The last time (several years ago) I bought a unit it as a SLIM KIC 2000. > > Check into www.kicthermal.com > > Phil > -----