The shielding cans material is CuNi18Zn20.



Best regards
Deng

From: Deng RongJun 
Sent: Wednesday, July 06, 2016 2:39 PM
To: [log in to unmask]
Subject: Shielding cans deformation during reflow

Hello fellow Techies,

I have got a problem with shielding cans deformation issue. There are several kinds of shielding cans on board, we have found one shielding have deformation after reflow, one side of shielding lift and not solder on board.
We also do a test, bake the individual shielding in oven with 230 degree, the shielding still have deformation and two corner have lift. Take out the shielding from oven and temperature go down, then shielding go back to good.
Any one of you have experience on this case?

Pictures:
https://goo.gl/photos/xQLbFT1AEwTR2iV68

Thank you very much.

Best regards
Deng