your design group should be able to tell you what is the engage/dis-engage time plus safety factor they use before select the connector - and determine what is you want to do going to eat up safety margin, potential risk... if it is not intended to be replaced by design. not us - at least not me. jk > All: > > Need some help determining if we can remove a press fit connector from a > PCB and replace it with a new press fit connector? PCB plating is ENIG. > This is a Class 3 assembly. I can't seem to find it in any IPC document. > Thanks in advance. > > Regards, > Steve Vargas > > ______________________________________________________________________ > This email has been scanned by the Symantec Email Security.cloud service. > For more information please contact helpdesk at x2960 or [log in to unmask] > ______________________________________________________________________ > ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________