https://www.jedec.org/sites/default/files/Master.pdf > I doubt there would be anything in the JEDEC standards, but I could be > wrong. Too many variations of a theme to cover them all. > But I would be sure to expect something on the part drawing. > > -----Original Message----- > From: Yuan-chia Joyce Koo [mailto:[log in to unmask]] > Sent: Monday, November 09, 2015 7:16 PM > To: TechNet E-Mail Forum; Stadem, Richard D. > Subject: Re: [TN] IPC SMT Lead to package co-planarity > > check jedec standard for components dwg package. plus your stencil paste > height after reflow. > On Nov 9, 2015, at 2:09 PM, Stadem, Richard D. wrote: > >> That would be in the component drawing from the vendor. >> >> -----Original Message----- >> From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez >> Sent: Monday, November 09, 2015 12:51 PM >> To: [log in to unmask] >> Subject: [TN] IPC SMT Lead to package co-planarity >> >> Fellow TechNetters: >> >> In which IPC STD will I find information of distance between the >> plastic housing standoff and lead height. INMHO the standoff >> should rest on the solder mask surface while the lead should have a >> slight gap to rest on the PWB copper pads. I hope that this makes >> sense. A print/spec is not readily available. >> >> Victor, >> >> >> ______________________________________________________________________ >> This email has been scanned by the Symantec Email Security.cloud >> service. >> For more information please contact helpdesk at x2960 or >> [log in to unmask] >> ______________________________________________________________________ >> >> ______________________________________________________________________ >> This email has been scanned by the Symantec Email Security.cloud >> service. >> For more information please contact helpdesk at x2960 or >> [log in to unmask] >> ______________________________________________________________________ > > ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________