Totally understand. And you were doing your job, so good for you! -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez Sent: Friday, October 16, 2015 8:35 AM To: [log in to unmask] Subject: Re: [TN] IPC-A-610 Whether acceptable or not, or otherwise, this was my observation. I don't create artifacts I just look for anomalies. Then try to figure out if a violation exists. Victor, -----Original Message----- From: Nutting, Phil [mailto:[log in to unmask]] Sent: Friday, October 16, 2015 8:19 AM To: TechNet E-Mail Forum; Hernandez, Victor G Subject: RE: [TN] IPC-A-610 Ahhhh... why would someone think that was acceptable? Sorry, just my opinion. Phil -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez Sent: Thursday, October 15, 2015 4:11 PM To: [log in to unmask] Subject: Re: [TN] IPC-A-610 Anymore input to my inquiry. Plastic housing connector edge/tab sitting/resting on top of two SMT ceramic resistors. Victor, From: Norman Mier [mailto:[log in to unmask]] Sent: Thursday, October 15, 2015 10:09 AM To: Hernandez, Victor G Subject: [TN] IPC-A-610 Victor, The answer is no spec. Look at 7.1.8 and as long as it meets the contract requirements or company requirements it's acceptable. Norman Mier BEST, Inc ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________