Any comment or advice? ________________________________________ From: TechNet [[log in to unmask]] on behalf of Tan Geok Ang [[log in to unmask]] Sent: Thursday, 12 February, 2015 5:42:25 PM To: [log in to unmask] Subject: [TN] Adhesion, Polymer Coating ( IPC-TM-650 2.4.16 ) Will like to check whether it is a common practice to subject parylene coated boards to thermal shock cycles before performing adhesion test method in accordance to IPC-TM-650 2.4.16 (similar to ASTM 3955)? At the same time, Section 4.0 (Apparatus or Material) of IPC-TM-650 2.4.16, does not indicated what tool is used to create the pattern under section 5.2 (though it refer to IPC-DD-135 which is an obsoleted standard) as the line width of the pattern is 0.1mm. Razor blade thickness is about 0.2mm. Hope to get advice you all. ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________