請問一下你們的鍍金曾要求厚度是多少

如果金厚不夠這種現象會出現的

 

From: TGAsia [mailto:[log in to unmask]] On Behalf Of 王道群
Sent: Friday, September 05, 2014 12:13 PM
To: [log in to unmask]
Subject: Re: [TGAsia] PCB鍍金層在回流焊後出現斑點

 

斑点应该是镀金下面的镍



 

在 2014-09-05 11:01:00，"Justin Wu" <[log in to unmask]> 写道：

各位專家,

 

請問PCB鍍金層在回流焊後出現斑點是何原因(注:不印刷锡膏也同樣存在類似問題)?

 

Thanks in advance!

 

Best regards,

 

Justin



__________ Information from ESET Endpoint Antivirus, version of virus signature database 10365 (20140904) __________

The message was checked by ESET Endpoint Antivirus.

http://www.eset.com

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
TGAsia是一个为业界同仁提供技术交流的平台。您可以在论坛上提出技术问题，交流行业经验，寻找供应商等。请勿发送任何招聘，广告信息。（注：对于寻求供应商的邮件，[log in to unmask]">请勿回复[log in to unmask],请私下和发件人联系）。如您需要退出该邮件论坛，请直接发送邮件至 [log in to unmask] ,谢谢。




______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
TGAsia是一个为业界同仁提供技术交流的平台。您可以在论坛上提出技术问题，交流行业经验，寻找供应商等。请勿发送任何招聘，广告信息。（注：对于寻求供应商的邮件，请勿回复[log in to unmask],请私下和发件人联系）。如您需要退出该邮件论坛，请直接发送邮件至 [log in to unmask] ,谢谢。


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
TGAsia是一个为业界同仁提供技术交流的平台。您可以在论坛上提出技术问题，交流行业经验，寻找供应商等。请勿发送任何招聘，广告信息。（注：对于寻求供应商的邮件，请勿回复[log in to unmask],请私下和发件人联系）。如您需要退出该邮件论坛，请直接发送邮件至 [log in to unmask] ,谢谢。