这种设计不能用,短路会搞死你的。 脱模时会出问题,焊点还是使用圆PAD Thanks and Best Regards Sonic Lu 陆尚 Autoliv Electronics China (ACE) Co.,Ltd Tel: +86-21-67109300-3162 From: TGAsia [mailto:[log in to unmask]] On Behalf Of wangruizhou Sent: 2014年6月18日 13:03 To: [log in to unmask] Subject: [TGAsia] 盗锡焊盘和测试点的设计 各位大侠们好,我们过波峰焊的插座有的盗锡焊盘和测试点集成到一块儿,大家说这种设计方式好不好? 现场拍摄的照片确实有连焊的,有没有好的改进建议?谢谢了! [cid:[log in to unmask]] ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask]<mailto:[log in to unmask]> ______________________________________________________________________ TGAsia是一个为业界同仁提供技术交流的平台。您可以在论坛上提出技术问题,交流行业经验,寻找供应商等。请勿发送任何招聘,广告信息。(注:对于寻求供应商的邮件,请勿回复[log in to unmask],请私下和发件人联系)。如您需要退出该邮件论坛,请直接发送邮件至 [log in to unmask]<mailto:[log in to unmask]> ,谢谢。 *************************************************************** Consider the environment before printing this message. To read Autoliv's Information and Confidentiality Notice, follow this link: http://www.autoliv.com/disclaimer.html *************************************************************** ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________