Hey there technetters. A while back, I sent a message about enig plating contamination in NON-plated holes. I've bounced it back to the board shop saying that it is unacceptable, but they claim it is due to 6012 3.5.2 I also think it's unacceptable in the 4552 spec. The design documentation clearly states non-plated. It's not plated, just partially plated. Any advice? Thanks. _____________________________________________________________________________________ Henry Rekers P. Eng | Schneider Electric | Global Supply Chain | Senior Manufacturing Engineer Phone: +1-250-652-7100 ext. 7510 | Toll Free: +1-866-466-7627 ext. 7510 | Fax: +1-250-544-2390 | Email: [log in to unmask] | Site: www.schneider-electric.com | Address: 2195 Keating Cross Road, Saanichton, BC, Canada, V8M 2A5 *** Please consider the environment before printing this e-mail ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________