Hi Lars! Got your pictures and have them posted. Here's the sketch: http://stevezeva.homestead.com/SolderSketch.pdf and here's the photo of the cap: http://stevezeva.homestead.com/Cap.jpg Steve -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Lars Wallin Sent: Thursday, February 6, 2014 6:15 AM To: [log in to unmask] Subject: [TN] VB: Lödproblem + bild Hello Technet, Please check the attach sketch. It involves soldering a large capacitor (20 x 30 x 40 mm see enclosed picture) and then mould in the whole board with a warm polyuretan mould mass. The requirement is that the solder joint should withstand 300 cycles (from-40C to +85 C). Figure A, can not cope with the requirement of 300 cycles. a = polyurethane mass. Which of the figures B-E do you think would be a better solution? Or would you suggest any other solution? Looking forward to your answer. Best Regards Lars Wallin IPC European Representative Location: Stockholm, Sweden Phone: +46 8 26 10 07 Mobile: +46 70 212 74 39 Email: [log in to unmask]<mailto:[log in to unmask]> ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________