Lee, What do you mean when you say "as long as y ou get the timings right"? Are you inserting through the liquid state or tack free/pre-cure state? Doug Pauls From: Lee Hitchens <[log in to unmask]> To: <[log in to unmask]> Date: 12/11/2013 07:07 PM Subject: Re: [TN] Press fitting Molex Micro-fit connectors through conformal coating... Sent by: TechNet <[log in to unmask]> Hello Steve Our coating services globally do this for a well known connector company for their back planes on very regular basis. Its highly efficient as long as you get the timings right. Let me know what you need to know about it or contact me directly off line to discuss. Best Regards Dr Lee Hitchens SCH Technologies Quoting Steve Gregory <[log in to unmask]>: > Hi all, > > > > I seem to have some sort of memory of press-fitting connectors through > conformal coating, but like a lot of memories nowadays I can't be > absolutely sure...(sigh) > > > > Have any of you ever done that? > > > > Steve > > > > > ______________________________________________________________________ > This email has been scanned by the Symantec Email Security.cloud service. > For more information please contact helpdesk at x2960 or [log in to unmask] > ______________________________________________________________________ > ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________