Check out Plasma Treat as well. The offer both open-air systems and low-pressure. Great surface prep prior to conformal coating, if that's what you are looking for. Lloyd Duso Diamond-MT Plant Manager (814) 535-3505 www.Diamond-mt.com On Mon, Nov 18, 2013 at 1:49 PM, Stadem, Richard D. < [log in to unmask]> wrote: > Would anybody out there care to share their experience with Plasma > cleaners? > I am looking at YES, Nordson March, and PlasmaEtch machines, but know very > little about them. > Feel free to contact me offline with both good and bad opinions, as well > as other brands you think I should look at. > Thanks > dean > > This message and/or attachments may include information subject to GDC4S > S.P. 1.8.6 and GD Corporate Policy 07-105 and are intended to be accessed > only by authorized recipients. Use, storage and transmission are governed > by General Dynamics and its policies. Contractual restrictions apply to > third parties. Recipients should refer to the policies or contract to > determine proper handling. Unauthorized review, use, disclosure or > distribution is prohibited. If you are not an intended recipient, please > contact the sender and destroy all copies of the original message. > > > > > ______________________________________________________________________ > This email has been scanned by the Symantec Email Security.cloud service. > For more information please contact helpdesk at x2960 or [log in to unmask] > ______________________________________________________________________ > ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________