Hi All

Any views or experience of replacing press fit connectors ? I have some concerns since I would assume there would be some copper thp distortion during the first fit and this may affect the reliability of the refit ? Some internet trawling seems to show that the "compliant" design pins, where there is a slot in the centre, are more compatible with remove and replace since some of the distortion will be in the pin. It is a "compliant" type of pin in my case but could do with some assurance that this would be OK to do.

Any thought / experiences appreciated

Regards

Bryan Kerr
BAE Systems
********************************************************************
This email and any attachments are confidential to the intended
recipient and may also be privileged. If you are not the intended
recipient please delete it from your system and notify the sender.
You should not copy it or use it for any purpose nor disclose or
distribute its contents to any other person.
********************************************************************

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________