Hello All,


 


After a wave solder process of a PCB with lots of through-hole components on it, I have seen that there are popcorn part near via on that PCB. The flatness of the first layer of the PCB is gone after that process. I think that moisture remaind inside PCB gets outsite during the wave solder process and cause this problem. I didn't put the PCB in a vacuum oven before wave solder. Is it possible that the problem is related of this. Is there any alternative solution about that problem?


 

Actually I applied the heat up and vacuum to empty PCB before all process of manufacturing. After that vacuum oven process, it has passed about 10 days to start the wave solder process. During that 10 days, did PCB get moisture inside?

 

Thank you advance.

 

Selim.


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________