Hello Lyon, You may look to the IPC A-610E at chapter 4.3.2 pag. 4-15 for references on lifted pads for press-fit. Regards. Francesco Francesco Di Maio IPC e Formazione Via Kennedy Ingresso 2, 20871 Vimercate (MB) - Italy Desk: +39.039.639.5921 - Mobile: +39.335.5693650 - Fax: +39.039.639.5051 E-Mail:[log in to unmask] GEST Labs S.r.l. a Socio Unico Societa’ soggetta a direzione e coordinamento da parte di SEM S.r.l. ai sensi dell’Art. 2497 bis c.c. Codice Fiscale, Partita IVA e Registro delle Imprese di Milano N 07602270964 – N. R.E.A. 1970226 - Capitale sociale € 500.000 interamente versato Sede Legale: Piazza Santa Maria Beltrade,.2 - 20123 Milano - Uffici Amministrativi e Stabilimento di Vimercate Via Lecco, 61 20871 Vimercate MB Please visit us at: www.GESTLabs.it and www.SemTechnologies.it << Rispetta l'ambiente. Non stampare questa mail se non è necessario >> ------ CONFIDENTIALITY & PRIVACY NOTICE ------ This e-mail message and any file transmitted with it, contains confidential or proprietary information. If you are not the intended recipient of this e-mail, please be informed that any use of the content hereof is prohibited. You are requested to notify immediately the sender and delete the content you received. "Stadem, Richard D." <[log in to unmask]> Sent by: TechNet <[log in to unmask]> 22/07/2013 15.13 Please respond to TechNet E-Mail Forum <[log in to unmask]>; Please respond to "Stadem, Richard D." <[log in to unmask]> To <[log in to unmask]> cc Subject Re: [TN] Regarding on press-fit connector lifted Perhaps no response because I, for one, do not understand what you are asking. Is the connector not flush to the PWB? Or is there a lifted pad? -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Lyon Yuan Sent: Saturday, July 20, 2013 7:33 PM To: [log in to unmask] Subject: Re: [TN] Regarding on press-fit connector lifted Any reply? Lyon Yuan -----Original Message----- From: [log in to unmask] [mailto:[log in to unmask]] On Behalf Of Lyon Yuan Sent: Saturday, July 20, 2013 7:11 PM To: [log in to unmask] Subject: [TN] Regarding on press-fit connector lifted Importance: High Hi Folks, What's the standard on press-fit connector lifted? Lyon Yuan ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________