We tend to stick to what is recommended by the coating manufacturer as
directed by the customer but when given a choice, Dynasolve products work
well.

We primarily use Dyna 190 or Humiseal 1063 for URs. Just about anything
will work on ARs, Humiseal 1080, Xylene, etc.

Silicones are messy and we prefer Dyna 210. Works like a champ.

Epoxy....uhhh, no. Really hard to remove that without damaging the board.

Lloyd Duso
Diamond-MT
Plant Manager
(814) 535-3505
www.Diamond-mt.com


On Wed, May 29, 2013 at 1:57 PM, Richard Kraszewski <
[log in to unmask]> wrote:

> Those of you who have done or have tried doing this realize what type of
> challenge this can be.  Thought I had resolved this some years ago, but now
> with the obsolescence of some strippers and increase in the various UV
> coatings we apply,  I need to address this again.   I can readily see that
> some UV coatings are much easier to strip that others.
>
> What type of chemical strippers do you guys use (both local & full)?
>
> Thanks
>
> Rich  Kraszewski /PLEXUS
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask]
> ______________________________________________________________________
>


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________