Hi again Doug, I should have looked at things in the link I sent a little closer and would have discovered that there are more than just a few nozzles that are like you describe, and here are a couple of them that have pictures, but they are not cheap: http://www.ellsworth.com/fisnar-5601406-dispensing-nozzle-4-5-in-spreader-0-75-in-x-0-125-in-orifice/ http://www.ellsworth.com/fisnar-5601405-dispensing-nozzle-4-in-45-spreader-0-5-in-x-0-0625-in-orifice/ Steve -----Original Message----- From: Steve Gregory Sent: Wednesday, January 16, 2013 4:52 PM To: [log in to unmask] Subject: Re: [TN] Wide adhesive nozzles Hi Doug, Fisnar makes what they call "Spreader" nozzles for their cartridges. Check out this link: http://www.fisnar.com/accessories_cartridges Then look at the right hand side of the picture beneath the "Dispensing Nozzles" link. you'll see a flat nozzle like you describe. Then click on the link and scroll down to where you see "Specialty Nozzles" and you'll see they have a couple of part numbers, one 3/8" wide and another 3/4" wide. If you click on the part numbers you'll be taken to the Ellworth page that shows what they cost, but they don't have any pictures of the actual nozzles unfortunately. Steve -----Original Message----- From: Douglas Pauls Sent: Wednesday, January 16, 2013 11:34 AM To: [log in to unmask] Subject: [TN] Wide adhesive nozzles Good morning all, A possibly silly question, which I will attribute to having only one Diet Dew so far today. You know how on Miracle Whip or other mayonnaise container, you have a cap which allows you to apply a wide ribbon of MW/Mayo to your substrate? What I am looking for is whether or not that same kind of approach can be taken with adhesives from a pneumatic dispense cartridge. I want to apply a fairly viscous adhesive in a 1/2" wide (or so) ribbon across a surface. I envision a 50cc syringe with a luer lock, ribbon dispense tip. Does anything like that exist and if so, what are your experiences. I have the same question in to our Ellsworth Adhesive rep but thought I would tap into this very large knowledge base. Doug Pauls ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________