Hi All, I am looking for an inspection fixture/table whereby I can change the angle of the Circuit Card Assembly when looking at solder joints under a microscope. It would of course have to be ESD safe. The ones I used at a previous company had locking knobs on either side such that you could adjust to any angle desired. The maximum size of the CCAs would be ~ 8" by 11" so the table surface could be even smaller than that. I am hoping to find an off the shelf unit and avoid the need for customer tooling and the added cost involved. I would appreciate any suggestions and of course if you are a supplier of this type product please contact me directly rather than using this very much appreciated forum. Thanks, Bob Furrow Quality Assurance Engineer Honeywell Aerospace - Sarasota 941-360-6285 [log in to unmask] ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________