Perhaps 3/8" thick G-10/FR-4 material? I know it isn't specifically anti-static. Blair On Wed, 19 Dec 2012 08:43:37 -0400, Graham Collins <[log in to unmask]> wrote: >Good day TechNet! > >We do high mix / low volume manufacturing, and often get oddball parts >in packaging that is not conducive to pick and place machines (e.g. a >bag of parts). I would like to get a supply of material so that we can >machine a tray to hold such parts and use it to feed them into the P&P >machines. We could make them out of material such as aluminum, but I'm >thinking that the stuff commonly used for wave soldering pallets would >be a lot easier to machine. Can anyone advise a source for this material? > >Thanks, and best wishes for the upcoming Christmas holidays! > >-- >regards, > >Graham Collins >Senior Process Engineer >Sunsel Systems >(902) 444-7867 ext 211 > > >______________________________________________________________________ >This email has been scanned by the Symantec Email Security.cloud service. >For more information please contact helpdesk at x2960 or [log in to unmask] >______________________________________________________________________