Syed, Not quite sure what you are looking for, but you should be able to just go out and buy bare die in waffle packs or on membrane for die attach and wire bond testing. Might be more productive to look for a generic jelly-bean part rather than 'scrap' die. Depends on what size die you may be looking for. Do you have an idea? Or, are you looking for daisy-chained die for contact resistance testing, etc.? Steve Creswick Sr Associate - Balanced Enterprise Solutions http://www.linkedin.com/in/stevencreswick 616 834 1883 -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Ahmad, Syed Sent: Wednesday, August 15, 2012 11:12 AM To: [log in to unmask] Subject: [TN] Die attach and wire bond test kit Does anyone know of a source for a die attach and wire bond (Au wire to Al pads) test kit? Thanks. Syed Sajid Ahmad Center for Nanoscale Science and Engineering (CNSE) NORTH DAKOTA STATE UNIVERSITY Phone 701 231 5880 www.ndsu.edu/cnse<http://www.ndsu.edu/cnse> [cid:[log in to unmask]] ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________