大家好, 有个问题想请教,助焊剂在过完波峰焊以后会发黑的原因是什么呢?是助焊剂本身的质 量问题还是什么别的原因? 请指教. ***************************************************** 太仓阿尔派电子有限公司 生产技术课:周博浩 地址:江苏太仓经济开发区广州西路1号 TEL:0512-53568111-6421 FAX:0512-53568112 E-Mail:[log in to unmask] 发件人: Jessy Lai <[log in to unmask]> 收件人: <[log in to unmask]> 日期: 2012-06-05 16:14 主题: [TGAsia] 答复: [TGAsia] 转发: 关于10.6.1---清洁度(助焊剂残留物)的判定 发件人: TGAsia <[log in to unmask]> 对于手焊元件后留下的助焊剂,只要透明,没有发黑均可以接受, 因为现在所用的助焊剂几乎都是免洗的,不像以前还有需要水洗, 有助焊剂是担心助焊剂会有导电或腐蚀PCB和元件,因此目前的 助焊剂只需透明没有发黑状况均可选择不用清洗(当然这是客户没 有特别要求的情况下的执行标准) Thanks & Best Regards, PE Jessy.Lai ************************************** Telephone : +86-0769-87290991转8829 No.6 Lindong 3Road Lin Cun Industral Center TangXia Dongguan Guangdong,P.R.C Email : [log in to unmask] Website : www.note.se 发件人: TGAsia [mailto:[log in to unmask]] 代表 Sammi Shi 发送时间: 2012年6月5日 15:25 收件人: [log in to unmask] 主题: [TGAsia] 转发: 关于10.6.1---清洁度(助焊剂残留物)的判定 大家好! 关于PCBA的助焊剂残留物的清洁度,有一个问题请教一下。 IPC-610E中定义如下: 注3与可接受等级的判定不知如何理解?假如生产中使用的免洗助焊剂,焊锡后的助 焊剂残留物需要清洗吗? 举个例子:附件图片中的蓝色零件使用alpha SAC305(免清洗型)锡丝手工焊接于PCB 上,焊后有图片中红色圈内的助焊剂残留物。 请问圈内的助焊剂残留物外观上可接受吗? 请帮忙解答,非常感谢! ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________