Victor, it works. It's a matter of dimensioning the drill holes. Frank Von: Victor Hernandez <[log in to unmask]> An: <[log in to unmask]> Datum: 28.06.2012 20:13 Betreff: [TN] Press Fit Pins on ENIG raw board Gesendet von: TechNet <[log in to unmask]> Fellow TechNetters: Are the pins in connector designated for Press Fit Pins gold plated for insertion into an ENIG raw board. What is the acceptable process. If both interfaces are gold plated with a thin layer of gold, the thin layer of gold would be wiped off during the insertion process. Then you would have a nickel to nickel mating surface. Does this sound correct. The interface should form a tight air seal. Victor, ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ . Der Inhalt dieser E-Mail ist für den Absender rechtlich nicht verbindlich. Informieren Sie uns bitte, wenn Sie diese E-Mail fälschlicherweise erhalten haben (Fax: +49-7551-891-4001). Bitte löschen Sie in diesem Fall die Nachricht. Jede Form der weiteren Benutzung ist untersagt. . The content of this e-mail is not legally binding upon the sender. If this e-mail was transmitted to you by error, then please inform us accordingly (Fax: +49-7551-891-4001). In such case you are requested to erase the message. Any use of such e-mail message is strictly prohibited. ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________