This reminds me of the time Doug was asked if he could hear in a vacuum. He asked" is it on "? Do everyone a favor and learn to love and respect a noble goal for a final finished tolerance as follows: · ± .003 for PTH dimensions · ± .005 for non-plated holes and internal milling/routing · ± .010 for the overall dimensional profile Dewey -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Ioan Tempea Sent: Thursday, May 31, 2012 8:45 AM To: [log in to unmask] Subject: [TN] PCB dimensions Dear Technos, Is it possible to keep the PCB dimensions within +/- 0.003"? I mean, even if the PCB fab does it, will these boards still be within tolerances after soldering? Thanks, Ioan Tempea Ingénieur principal de fabrication / Senior Manufacturing Engineer <http://www.digico.cc/> 950 RUE BERGAR, LAVAL, QC, H7L 5A1 <http://g.co/maps/2gh3f> T+ 1 (450) 967-7100, EXT244 ------------------------------------------------------------------------ <http://www.facebook.com/pages/Digico/277076778479> ------------------------------------------------------------------------ Lauréat Dunamis 2012 <http://digico.cc/dunamis-2012/> Entreprise manufacturière / Gestion du capital humain ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________