Here's an article I wrote about that... http://www.frontdoor.biz/HowToPCB/HowToPCB-extra/ResolvingComponentPolarityProblems.pdf onward thru the fog, Jack On Tue, Aug 23, 2011 at 9:54 AM, Mark Larson <[log in to unmask]> wrote: > exactly > > a zero rotation in the CAD data should equate to a zero rotation at > insertion, that is to say no rotation needed. > > > --------------------------------------------------------------------------------- > DesignerCouncil Mail List provided as a free service by IPC using LISTSERV > 16.0. > To unsubscribe, send a message to [log in to unmask] with following text in > the BODY (NOT the subject field): SIGNOFF DesignerCouncil. > To temporarily stop/(restart) delivery of DesignerCouncil send: SET > DesignerCouncil NOMAIL/(MAIL) > For additional information, or contact Keach Sasamori at [log in to unmask] or > 847-615-7100 ext.2815 > > --------------------------------------------------------------------------------- > ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ --------------------------------------------------------------------------------- DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0. To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF DesignerCouncil. To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL) For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ---------------------------------------------------------------------------------