Folks, Thank you to all who shared their experience/knowledge with the above stated topic. Victor, From: Reuven Rokah [mailto:[log in to unmask]] Sent: Wednesday, May 25, 2011 7:20 AM To: TechNet E-Mail Forum; Hernandez, Victor G Subject: Re: [TN] Pres Fit Pin Technology guideline I think HASL finish is more tolerable than OSP finish in tolerances. The additional of Sn/Pb or SAC coating on the Cu plating give grease effect and more contact area at the Press fit pins corners. Reuven On Tue, May 24, 2011 at 6:05 PM, Victor Hernandez <[log in to unmask]<mailto:[log in to unmask]>> wrote: Fellow TechNetters: What is the consensus on the use of Press Fit Pins insertion into a final surface board finish of OSP or HASL? Is there a difference in the term Press Fit Pins or Compliance Pins? Victor, ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please contact helpdesk at x2960 or [log in to unmask]<mailto:[log in to unmask]> ______________________________________________________________________ --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 16.0 To unsubscribe, send a message to [log in to unmask]<mailto:[log in to unmask]> with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]<mailto:[log in to unmask]>: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]<mailto:[log in to unmask]>: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives For additional information, or contact Keach Sasamori at [log in to unmask]<mailto:[log in to unmask]> or 847-615-7100 ext.2815 ----------------------------------------------------- -- Best Regards, Reuven Rokah Mobile: 972-52-60-120-18 Tele-fax: 97239360688 <http://www.rokah-technologies.com/>[log in to unmask] <mailto:[log in to unmask]>[log in to unmask]<mailto:[log in to unmask]> www.rokah-technologies.com<http://www.rokah-technologies.com/> [http://royiro.weebly.com/uploads/6/3/6/9/6369812/4511319.jpg?303] ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 16.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------