Hi Everyone, I hope someone can send me their recommendations (on or off list) on BGA re-ball kits. The system will see very light use, only about 1-5 pieces done per month on BGAs not less than 0.8mm pitch, and less than 300 balls per part. I think we will place an emphasis on ease of use to get good results over other factors. I have been leaning toward the SolderQuik by Winslow, but that is based on perceived ease of use and not any real data. Thank you very much for any help you can pass along, and I hope things are going well for you all. Richard Hatano Joby Energy Inc. ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------