各位坛友
今日在生产过程中,看到了一个现象,就此异常现象是属于白斑还是微裂纹产生了争议,照片如下。
附件中可见的焊点为压接的插针;整个PCBA有压接插针的地方有如图所示的异常情况,其它焊接点周围及板面正常。
在试验过程中,插针压接在PCB上以后,并无白斑或微裂纹等异常情况;当过完波峰焊之后,如图所示的情况就出现了。请问此种情况是应属于白斑还是微裂纹?
此种异常情况出现的可能原因有哪些?(注:插针压接及波峰焊过程我们试验过程都做了记录,没有异常)
请指教!
王萍
*** Confidentiality Notice: This e-mail, including any associated or attached
files, is intended solely for the individual or entity to which it is addressed. This e-mail is confidential and may well also
be legally privileged. If you have received it in error, you are on notice of its status. Please notify the sender immediately
by reply e-mail and then delete this message from your system. Please do not copy it or use it for any purposes, or disclose its
contents to any other person. This email comes from a division of the Invensys Group, owned by Invensys plc, which is a company
registered in England and Wales with its registered office at 3rd Floor, 40 Grosvenor Place, London, SW1X 7AW (Registered number 166023).
For a list of European legal entities within the Invensys Group, please click this Link.
You may contact
Invensys plc on +44 (0)20 3155 1200 or e-mail [log in to unmask]. This e-mail
and any attachments thereto may be subject to the terms of any agreements between Invensys (and/or its subsidiaries and
affiliates) and the recipient (and/or its subsidiaries and affiliates).