I have an assembly we had to replace a component, in the cleaning process some of the silkscreen rubbed off. The assembly is ready to ship! IPC-610-D page 10-26, section 10.3.2 states Defect - Class 1,2,3 Missing or illegible markings or reference designators for component location, or component outlines. Would this apply to bare board only? Or do I have to replace silkscreen? Linda Langley CIT Training Specialist Jabil Circuit 248-292-6176 ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------