Dear Snow,
Could you please share the original text with us? So we can convince our customer.
Thanks with best regards,
Victor


在2010-04-27 14:03:02，snow_fu <[log in to unmask]> 写道：


Please refer to IPC J-STD-001 4.2.2.

Temperature control spec is 18ºC ~ 30ºC & Humidity is 30% ~ 70%.

Actually We need to control humidity not high than 60% since there are some MSD component using in factory.

 

 

发件人: TGAsia [mailto:[log in to unmask]] 代表 txb1027
发送时间: 2010年4月26日 20:10
收件人:[log in to unmask]
主题: [TGAsia] SMT车间环境温湿度的要求

 

 





Dear all,

请教一个SMT车间温湿度的控制要求，引用IPC什么标准?当前我们是18-26.度湿度是40%-60%，总是不达标，想修改这个范围，但不知道引用什么标准。

 

有域名马上来，网易免费送你200户域名邮箱
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________


______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________