Good morning,
Is anyone out there being asked by your fabrication shops to add teardrops to all round pads, or just pads where the minimum annular ring is less than .5mm?
Regards,
Colleen
Colleen Salvaggi, C.I.D.+
Senior PCB Designer
Bose Corporation
The Mountain
Framingham, MA 01701-8863
508-766-6520
CONFIDENTIALITY NOTICE: This e-mail and any attachments relate to the official business of Bose Corporation and are proprietary to Bose. This e-mail and any attachments may contain information which is confidential, proprietary, privileged or otherwise protected by law. The information is solely intended for the named addressee (or a person responsible for delivering it to the addressee). If you are not the intended recipient of this message, you are not authorized to read, print, retain, copy or disseminate this message or any part of it. If you have received this e-mail in error, please notify the sender immediately by return e-mail and delete it from your computer.