Hi all I read recently an article/paper proposing a new procedure or standard for assessing solder paste. Essentially it proposed a standardised test board (similar to those used by some larger companies now). Unfortunately I have filed it so securely I can't find it. If anybody can send me a link I would be much obliged. Regards Mike ***Please note last shipping day from the UK will be18th December (Mainland GB 22nd). Best Wishes to everyone for the Christmas Season*** Mike Fenner, Technical Manager Indium Corporation Europe Mob: + 44 7810 526 317 Skype: mike.fenner Tel: + 44 1908 580 400 Fax: + 44 1908 580 411 www.indium.com --------------------- Indium Corporation Incorporated in New York, USA Registered office: (Not for correspondence) 77-97 Harpur Street, Bedford , UK Registered number: fc16473 ***This email, its content, and any files transmitted with it, are intended solely for the addressee(s) and may be legally privileged and/or confidential. If you are not the intended recipient, please contact the sender by return and delete the material from any computer. Any review, retransmission, dissemination, or other use of, or taking of any action in reliance upon this information by persons or entities other than the intended recipient is prohibited. Messages sent via this medium may be subjected to delays, non-delivery, and unauthorized alteration. This email has been prepared using information believed by the author to be reliable and accurate, but Indium Corporation makes no warranty as to accuracy or completeness. Indium Corporation does not accept responsibility for changes made to this email after is was sent. Any opinions or recommendations expressed herein are solely those of the author. They may be subject to change without notice.*** --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------