I just checked the latest Draft of IPC-2222A and its not there either,
but it is in IPC-4101 as Table 3-7.
 
jack
 


 
On Wed, Oct 28, 2009 at 1:29 PM, Brooks, Bill <[log in to unmask]> wrote:
IPC - FYI...

In going over the IPC-2222 4.3.7.5 Thickness Class Tolerance Designation
looking for a tolerance callout for thickness I ran across a problem...
The table indicating the tolerances for Class 1, 2, and 3 seems to be
missing in the document. Did I miss it somewhere?

Best regards,


Bill Brooks, CID+

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------

-------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field):
SIGNOFF DesignerCouncil
To temporarily stop/(start) delivery of DesignerCouncil for vacation breaks send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext. 2815
-------------------------------------------------------------------------------