Quick question: I usually have via's plated to a minimum of 1mil.  I
have a high current design where I'd like to have those via's plated to
2mil (near 2oz, to match the 2oz spec for the layers) -- but the board
has some 15mil vias and is a 125mil thick board.  Would a typical board
house be ok with this?  I don't care about getting those 15mil mil
diameter via's to 2mil barrel plating, only the 32mil ones need to be
that thick.

Shawn Upton, KB1CKT
Test Engineer
Allegro MicroSystems, Inc
[log in to unmask]
603.626.2429/fax: 603.641.5336

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------