I'll use hatched planes occasionally, to "even" etching across the board
material, but only on mixed plane/signal layers.  It depends upon the
board, how much copper tracking  and plane area is on the board and in
what areas.

James

********************************************************

The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material. If you are not the addressee, any disclosure, reproduction,
copying, distribution, or other dissemination or use of this transmission in
error please notify the sender immediately and then delete this e-mail.
E-mail transmission cannot be guaranteed to be secure or error free as
information could be intercepted, corrupted lost, destroyed, arrive late or
incomplete, or contain viruses.
The sender therefore does not accept liability for any errors or omissions
in the contents of this message which arise as a result of e-mail
transmission. If verification is required please request a hard copy
version.

********************************************************

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------