Hi All,

We have a rigid flex that has a BGA-113 (microstar BGA) package to be
mounted to it. The routing in this area on the top layer leaves me with
.0005 of soldermask clearance from the edge of the BGA pad and .003 distance
from the edge of the soldermask to the nearest track- in other words I have
.0035 of clearance from pad edge to next track assuming a perfect etch and
perfect soldermask registration.

Having rooted around Texas Instruments web site I believe that it may be
possible to reflow this BGA without adding solder paste to the pad - just
letting the ball collapse do the attachment. If my scenario is correct I
could open up the soldermask and not have too many concerns about bridging
between the BGA pads and the tracks. Any thoughts or comments would be
appreciated.

Thanks Steve Kelly 

 

Steve Kelly (PLEASE NOTE NEW E-MAIL ADDRESS)

(416) 750-8433 (work)

(416) 750-0016 (fax)

(416) 577-8433 (cell)

 


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------