Inge, Have you checked ebay? Vladimir ------Original Message------ From: Inge Sender: TechNet To: [log in to unmask] ReplyTo: TechNet E-Mail Forum ReplyTo: Inge Sent: Mar 31, 2009 11:50 Subject: [TN] Nikon microscope camera DXM-1200 Hi all and a half, anyone who happens to have such a one? I need a electric wiring diagram or a service manual for the framegrabber board built for that camera. Nikon does not give support and I don't like to pass such a good camera equipment to the waste bin (best camera on the market when I bought it). The program works, but the camera framegrabber window on the screen just shows a zigzag pattern. Camera produces 1V p-p video signal on two wires and sync on the third (Y), 12 frames a second, a variant on RGB. I know it's crazy to repair on component level, but I use to at least make a try. Old habit. The grabber manufacturer is not either service minded (TechnoMedia). You could of course buy general framegrabber board for PCI slots, but then you just get a picture and no tool box for annotation , measuring, picture options etc. /Inge --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- SENTEC 11 Canadian Road, Unit 7. Scarborough, ON M1R 5G1 Tel: (416) 899-1882 Fax: (905) 882-8812 www.sentec.ca