Typically in good shop will plate to 1.5 mils in the hole is for higher copper weights without causing plating failures. Thank you, Jim Mahoney Quick Turn Flex Circuits, LLC Applications Project Manager P# 603-821-6571 F# 603-821-5723 M# 603-305-6250 ** This email and all attachments have been scanned prior to being sent** Confidentiality Notice: This page and any accompanying documents contain information that is confidential, privileged or exempt from disclosure and is intended for the exclusive use of the addressee. If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or use of the contents of this information in any manner is strictly prohibited. -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Pete Houwen Sent: Wednesday, September 24, 2008 8:59 AM To: [log in to unmask] Subject: Re: [TN] Minimum Finished Copper Thickness Finished copper thickness is generally specified as a minimum thickness measurement per the design intent. Check IPC-A-600, 3.2.3 It is more difficult to maintain copper thickness with heavy copper and poor distribution, it might cost a bit more and you can't go to just any cheap shop, but it can certainly be done consistently. --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------