We put a lot of money and effort into material and finish selections in the 
RoHS chageover.

We have strict specifications on our fabrication drawings.

We have previously fully qualified 3 high volume and 2 prototype PCBs, and 
maintain them in a world wide AVL.

but purchasing sees pennies.............

This is just a proposed vendor - only sample quantites assembled, we haven't 
ordered anything yet (I hope).

So far the proposed vendor has:
claimed to be a fabricator, but is actually a broker
fabricated at two shops, neither was included in the site visits or D&Bs
switched the laminate we approved (twice)
changed layer spacing
used some alien plating material
performed microsectioning and solder testing on a non-RoHS PCB, but shipped 
a completely different (hopefully RoHS) panel
The other (passed) microsection showed innerlayer separation.
Shipped PCBs with soldermask on pads.

Best scenario is that this finally wakes purchasing up to what I've been telling 
them about buying boards in China.  Worst case is - they buy these anyway.

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------