Yes. This is how the problem manifest itself, with a bulge on the top of the cap. However, we did not have the contamination shown just to the left of the coil! :-) -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Steve Gregory Sent: Tuesday, July 22, 2008 12:17 PM To: [log in to unmask] Subject: [TN] RE: Bulging Cap Hi Ioan! I'm doing fine. Staying busy trying to get back into the swing of things at work after being gone for three-weeks. We're also getting our Select-X installed on our new wave machine today, so I'm sure I'll be tied-up this afternoon learning how to use it. Anyways, I have your picture posted. It's here: http://stevezeva.homestead.com/files/Bulging_Electrolytics.jpg Steve ________________________________ From: Ioan Tempea [mailto:[log in to unmask]] Sent: Tuesday, July 22, 2008 10:50 AM To: Steve Gregory Subject: Bulging Cap Hi Steve, How are you? I hope everything is well! I have asked a question on Technet about the Panasonic caps and I think it would be a good idea to refer to the attached picture that shows the bulging at the top of the parts. I wonder if this is acceptable or not. Could you please post the image on your site? Thanks, Ioan --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------