TechNetters, may I have some advice or recommendations on training in doing printed circuit cross-sections, in the eastern US? It looks like IPC 7711/7721 training is not hard to find, but is anyone doing PCB cross-section training alone? Thanks for any guidance. Louis Louis Hart Compunetics Monroeville, PA USA [log in to unmask]<mailto:[log in to unmask]> 412-858-1272 --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------