Hi David, We manufacture both types of stencils. Part of the answer to your question depends on what you are currently paying for your laser cut stencils. In general, an electroformed nickel stencil will cost about 2-3 times what a laser cut SS stencil will. Regards, Fred -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of David Tremmel Sent: Tuesday, April 08, 2008 5:10 PM To: [log in to unmask] Subject: [TN] Stencils Hello, How is everyone? Would anyone mind venturing a price comparison of a typical laser-cut stencil and an electroformed stencil would be approximately 15" x 15"? Are the electroformed %10 more expensive? %15? Thank you in advance for your answers, David Tremmel Value Recovery --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------