Rex Waygood Technical Manager PartnerTech Poole Ltd Benson Road Poole Dorset BH17 0RY United Kingdom Tel: +44 (0)1202 674333 Fax: +44 (0)1202 678028 DDI: +44 (0)1202 338222 Mob: +44 (0)7887 997403 [log in to unmask] www.PartnerTech.co.uk -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Ioan Tempea Sent: 28 November 2007 15:55 To: [log in to unmask] Subject: [TN] SN100C process Dear Technos, I have moved to this new company and here we're running SN100C in wave, as opposed to the SAC305 I used to have before. So I have to start all over defining the baseline process parameters. Besides frequent shorts and solder not going all the way to the top, we have an issue with solder freezing at the corners of the solder pot. To overcome this "chilly" issue, we were suggested to run the pot at 540F! So I would like to know where you are with the SN100C: * What pot temperature 265C * What conveyor speed range ~1.2 metres/minute * What flux (special formulation for the alloy or regular, solids content, water or alcohol based, etc) Kester 979 * Nitrogen or not Not * Other particular points of interest Vectra/2 forced convection preheats/ all carrier based/ Chip wave/ Air knife Of course an insight regarding the attainable defect free yields would also be appreciated. Getting better, not quite down to SnPb levels yet Thank you, Ioan --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- ------------------------------------------------------------------------------- The information contained within this e-mail and any attachments contained therein may be confidential and/or legally privileged and is for the use of the intended recipient only. If you are not the intended recipient please delete it from your system and notify the sender by return e-mail. The content of this e-mail may not be copied or disclosed to any third parties without prior permission from the sender. E-mail is susceptible to data corruption, interception, tampering and viruses. We do not accept any liability for any such incidents or any consequences thereof. --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------