Kerry, A two part epoxy by 3M followed up with a 200F bake to fully cure should be fine. Tony Steinke -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Kerry McMullen Sent: Wednesday, August 15, 2007 2:28 PM To: [log in to unmask] Subject: [TN] Drill Rework Hi, I have a .062 FR406 board where I need to drill out a trace that is causing a problem. The trace is .020" down in the board (Layer 4). The drill size is .012. After I have drilled out (opened) the trace, what do you suggest I fill the drill hole with? We have done the rework, and it works fine. I am just curious as to if I should fill the hole with epoxy. Thanks in advance, Kerry Kerry McMullen Principal New Product Mfg. Engineer LTX Corporation 825 University Avenue Norwood, MA 02062-2643 (T) 781-467-5468 (C) 508-631-1832 (F) 781-461-0993 --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------