I would make sure the tabs and webbing holes are represented in the master drawing - theirs or yours approved - this will provide an allowance for the residual material left after depanelization. Jeffrey Bush Director, Quality Assurance and Technical Support VERMONT CIRCUITS INCORPORATED 76 Technology Drive - POB 1890 Brattleboro, Vermont 05302 Voice - 802.257.4571 ext 37 Fax - 802.257.0011 <http://www.vtcircuits.com/> -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Joel Alexander Sent: Wednesday, January 24, 2007 9:04 AM To: [log in to unmask] Subject: [TN] Question about cracker holes (panel breakaways) We have been using panels with internal breakaways for over 20 years. There is a slight amount of material left when they are broken but we have never had a customer complaint about this. We have started doing military business and they are rejecting everything because the cracker hole areas exceed print dimensions. It is obvious that the additional material at the cracker hole location does not have any impact to the end use. Is there any industry standard that would permit the use of cracker holes Also has anyone had similar experiences dealing with military customers and if so what was the end result? Joel Alexander Quality Assurance Manager --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------