Along the same lines, sort of. If you use COTS magnetics and the supplier changes to no-clean and after assembly you put that in your ROSE tester the readings can go through the roof. If you are satisfied that the mag manufacturer is doing everything right and you can live with no-clean flux on the mag, how do you perform a ROSE test on the assembly and trust the reading? Thanks, KennyB --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------