Hi all, Thought I should share this with the forum. This was actually put up on the SMT forum by one of the members today http://www.europeanleadfree.net/pooled/articles/BF_NEWSART/view.asp?Q=BF_NEWSART_209824 Regards, Amol Kane M.S (Industrial Eng.) Process Engineer Harvard Custom Manufacturing, Inc. 941 Route 38 Owego, NY 13827 Phone: (607) 687-7669 x349 [log in to unmask] www.harvardgrp.com CONFIDENTIALITY NOTICE: This e-mail, and any attachments, is for the sole use of the intended recipient(s) and may contain information that is confidential and protected from disclosure under the law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail, and delete/destroy all copies of the original message and attachments. Thank you. --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------