Hello everyone, I have heard of stencils that are made much thicker than normal to allow machined clearances for leads of TH components mounted on the opposite side of the PCB. Has anyone succesfully used this technique? If so, are there some recommended guidelines? I can imagine there are limitations on pitch size.. TIA. Kevin Glidden Mfg Eng Luminescent Systems Inc. --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------